Good day,

I am stuck. I would like to "lessen" the watershed step effect that I get in this, but I cannot figure out how to do so. I like the look of the deep saturated areas but not the lighter "steps" that happen in inbetween. I would like to remove those "in-between lighter areas-hope that makes sense! Any ideas on what I could do to mitigate? Thanks!

Views: 66

Attachments:

Reply to This

Replies to This Discussion

If you can post the preset you are using i might be able to comment further. Otherwise (without knowing how it's setup), it's a matter of playing with the different effect controls.

Thank you! I have attached the preset I am currently working with. 

Attachments:

Ok, looked at the preset. I thought you were referring to one of the Watershed ip op effects before i downloaded your preset below. But it's a paint preset using the watershed dm path start generator.

I'm still unclear on how you want to change it. What exactly do you mean by the 'watershed step effect'? Are you talking about the spacing of the paths that fill in the watershed regions? Or?

There are a lot of different things you can adjust in the paint preset. Like the spacing or fill pattern of the path shape regionize fill (region pattern spacing and region pattern type).

Or any of the different control sin the Paint Fill Apply control panel, which is going to change the coloring quite a bit. You have Dif Darken option for Composite in Paint Fill Apply. So you could change that.

Thank you! I will work with these two settings. 

RSS

Latest Activity

Thor Johnson posted a video

Dancing Alien

A character I made in ZBrush, animated in Blender, then processed in Studio Artist with MSGs I made, and in the first section a movie brush.
3 hours ago
David Buckle posted a photo
22 hours ago
mark g replied to mark g's discussion question about alpha selections when saving sessions
"Thanks, I will do that, I just thought I would ask in case I was missing something."
yesterday
David Buckle posted a photo
yesterday
Synthetik Software replied to mark g's discussion question about alpha selections when saving sessions
"I'll take a look at the session code for the future. I guess for now you could make an extra layer before you save your session file, and set it to the selection. then you would have it available when you open the session file in the extra…"
yesterday
mark g replied to mark g's discussion question about alpha selections when saving sessions
"I have, but my problem lies in the fact that that I can see the selection I made in my original session, but the image is no longer there outside of the selection. Which means I can't change the selection..if I do make a new selection on the…"
Tuesday
Synthetik Software replied to Nora Laiken's discussion Where Are Favorites Stored?
"If studio artist is loading it into the preset browser then the category folder and associated preset files are on your computer. You could try searching in the finder for individual preset file names in it? You might also want to check your file…"
Tuesday
Synthetik Software replied to mark g's discussion question about alpha selections when saving sessions
"Have you tried setting the selection to the current layer alpha channel after opening the session? then you could do what you were doing before you saved the session."
Tuesday

© 2019   Created by Synthetik Software.   Powered by

Badges  |  Report an Issue  |  Terms of Service